The Lavelast Anticarbonatazione is a ready to use, in particular pasta, fine resin fillers to ensure greater flexibility. The product spreads like a traditional painting, when it is dry to form a continuous film very tenacious and resilient and well clinging to support. The Lavelast Anticarbonatazione has an exceptional degree of elasticity to both high and low temperatures and long-lasting.
It is also waterproof, while retaining sufficient vapour permeability and is used as a decorative-protective painting in all those cases where you can get cracking and movement of support.
Preparation of support
On concrete support is recommended to apply it with Rough Bottoms or Murisol K (solvent insulation) very diluted and then two coats of Lavelast Anticarbonatazione consistently stretched to form a continuous film.
Vertical application
After properly prepared with support Rough or Murisol K, apply two coats of Lavelast Anticarbonatazione 24 hours apart from each other. The first coat dilute with 10% water, and the second with the 5% water. The best finish is obtained with a sponge roller or brush bristle. It forms a smooth or slightly wavy with very light skin. Average consumption 0.5 kg/m2. You will get a smooth and shiny-satin. Do not apply the product Lavelast Anticarbonatazione on moist or wet, with temperatures below +0 °C.
Store the product cool, but protected from Frost. If the facade there are crackles or cracks, you should open the crack, caulk with adhesive and apply a coat of Lavelast Anticarbonatazione with F3 fabric width 10 cm.
Technical data
- Viscosity: 20,000 centipois to +20 °C
- Specific weight: 1.27 kg/l
- Nature of binder: styrene acrylic emulsion
- Film: satin appearance
- Colour: as per sample
- Drying: touch 3 hours, 36 hours in depth
- Resistance in salt room: 360 hours, as well as remarkable.
- Resistance to alkalis: no structural or chromatic variation.
- Yield: variable depending on the vertical or horizontal use.
