The Elast Siloxan INTO is a coating for immediate use paste, based on special acrylic-siloxane resins, fillers and fine sand silica quartz.
The product extends like a traditional coating, when it is dry turns out to be very tough and elastic and well clinging to the support, allowing a very high water repellency and water vapor diffusion. Its uses are to be optimal on the fronts where there appears to be numerous microcracks
Preparation of support
The Elast Siloxan INTO grips in any support, provided the latter is not dusty, crumbly or the presence of grease, oil, etc…
On support in plastic, make the surface a bit ‘rough using sandpaper and remove dust.
In non-dusty, non-absorbent , thoroughly clean with a cloth moistened with alcohol or solvent.
On the walls with plaster is advisable to apply Siloxan Fixative and then the Elast Siloxan INTO spread with a plastic trowel.
On plastered surfaces or coated, after properly prepared the surface with fixative Siloxan, apply two coats of Elast Siloxan INTO after 24 hours apart with a particle size 0.6mm. For grain size 1.00 mm, 1.20 mm, 1.50 mm just one hand. It forms a surface for plaster effect. The average consumption is 1.5-2.5 kg/m2 (Varies depending on size).
Do not apply Elast Siloxan INTO with temperatures below +0 °C.
Keep from freezing.
The material if stored in a suitable place, in the original packaging, for a period of one year duration.